The laser driver kit can supply regulated current to any laser diode that requires a current up to 3A, It will power almost any laser diode from the lowest range 35mA Blu-ray laser, up to a multi-amp green laser.
- This kit is only a regulator and NOT a fully working laser system.
- This kit is only intended to be part of a laser diode system for holography or light show for entertainment purposes.
- You cannot use this kit to build a device that is against the law
Kit Includes:
- Schematics
- Instructions for assembly, testing and calibration
- Printed circuit board (PCB)
- All semiconductors
- All capacitors
- All resistors except the two larger resistor in front. You must determine yourself experimentally the one(s) appropriate for your diode requirements. This is explained in the documentation.
- Test points to measure and monitor current through laser diode while in operation.
Laser Diode (not included) Close Up
LDD-01 $34.95 (Kit Requires Assembly)