Images Scientific Instruments Inc. radiation symbol






DIY Steampunk Geiger Counter - Page 8

DIY Build a Steampunk Geiger Counter

Reattach the saw assembly and dry fit the lever of the lever switch through the hole. You may need to increase the size of the hole to allow clearance for the lever to move enough to switch on and off. When the hole is the right size, position the lever switch so that rotating the saw, turns the switch on and off.

Mark the position of the switch and then drill two holes to mount the switch to the case, see figure 16.

Back Plate Lever Switch Steampunk Geiger Counter

Reassemble the saw on the case alone with the lever switch and check functionality, see figures 17 and 18.

Front Lever Switch Steampunk Geiger Counter
Side Lever Switch Steampunk Geiger Counter

Buy DIY Steampunk Components Here


Previous Page | Next Page